Black plate (375,1)
7. Remove the adapter.
8. Install the new bulb in the reverse order
of the removal procedure.
Fog light bulbs
í
1. Make sure the ignition is switched off,
and the headlight switch is off.
2. Turn the screws and the center section
of the plastic retainers
counterclockwise and remove them,
then partially peel back the mudguard.
Removal
Installation
3. Disconnect the electrical connector
from the bulb by pressing the tab on
the connector with your finger and
pulling the connector downward.
4. Turn the socket and bulb assembly to
remove it. Carefully remove the bulb
from its socket in the reflector b y
gently pulling it straight backward out
of the socket.
5. Install the new bulb in the reverse order
of the removal procedure.
Front side-marker lights
1. Make sure the ignition is switched off,
and the headlight switch is off.
Maintenance and Care
Owner Maintenance
8-39
í
Some models.
MX-5_8CC2-EC-11F_Edition1 Page375
Tuesday, May 31 2011 12:0 AM
Form No.8CC2-EC-11F
To Next Page
Loading...
