4
–
167
When Driving
i-ACTIVSENSE
Steering operation assist OFF (non-operational)
The steering operation assist for the Lane-keep Assist System (LAS) & Lane Departure
Warning System (LDWS) can be changed to non-operational (OFF).
Refer to Setting Change (Personalisation Features) on page 9-17 .
When the steering operation assist has been changed to inoperable (OFF), operate the Lane-
keep Assist System (LAS) & Lane Departure Warning System (LDWS) as follows:
System operation
If the Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) OFF
indicator light in the instrument cluster turns off when the ignition is switched ON, the
system goes on standby.
If the Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) OFF
indicator light in the instrument cluster turns on when the ignition is switched ON, press the
Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) OFF switch so
that the system goes on standby.
Drive the vehicle in the centre of the vehicle lane while the system is on standby. The
system becomes operational when all of the following conditions are met.
The system detects white (yellow) lane lines on both the right and left sides.
The vehicle speed is about 60 km/h (37 mph) or faster.
The vehicle is driven on a straight road or road with gentle curves.
The engine is running.
The Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) goes on
stand-by status in the following cases:
The system cannot detect white (yellow) lane lines.
The vehicle speed is less than about 60 km/h (37 mph).
The vehicle is making a sharp curve.
The vehicle is making a curve at an inappropriate speed.
/C\FCA(,'''A'FKVKQPKPFD/C\FCA(,'''A'FKVKQPKPFD
To Next Page
