Mazda 3 - Page 312

4 – 168
When Driving
i-ACTIVSENSE
NOTE
 
The Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS)
remains on stand-by until it detects white (yellow) lines on both the left and right sides,
or on either side.
 
When the system detects a white (yellow) lane line on one side only, the system will
not activate warnings for the lane line on the side that is not being detected.
 
The distance and warning sensitivity (likelihood of a warning) which the system uses
to determine the possibility of a lane departure can be changed.

Refer to Setting Change (Personalisation Features) on page 9-17 .
Vehicle lane line display
When the Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS)
becomes operational while on standby, the vehicle lane lines are displayed in the active
driving display. The system changes to operational status display when the system detects a
white (yellow) line on either the left or right.
System condition Indication on display
Stand-by
Operation status
Auto cancel
Under the following conditions, the Lane-keep Assist System (LAS) & Lane Departure
Warning System (LDWS) is automatically cancelled. The Lane-keep Assist System (LAS)
& Lane Departure Warning System (LDWS) is automatically re-enabled when it becomes
operational.
 
The temperature inside the camera is high or low.
 
The windscreen around the camera is foggy.
 
The windscreen around the camera is blocked by an obstruction, causing poor forward
visibility.
/C\FCA(,'''A'FKVKQPKPFD/C\FCA(,'''A'FKVKQPKPFD 