Black plate (159,1)
For a single wiping cycle, push the lever
up to
.
Variable-speed intermittent wipers
Set the lever to INT and choose the
interval timing by rotating the ring.
INT ring
Type B (With AUTO position)
Turn the wipers on by pulling the lever
down.
― Mist
AUTO ― Auto control
1 ― Low speed
2 ― High speed
For a single wiping cycle, push the lever
up to
.
AUTO (Auto-wiper control)
When the wiper lever is in the AUTO
position, the rain sensor senses the
amount o f rainfall on the windshield and
turns the wiper on or off automatically
(off―intermittent―low speed―high
speed).
The sensitivity of the rain sensor can be
adjusted by turning the switch on the
wiper lever.
From the center position (normal), turn
the switch towards (+) for higher
sensitivity (faster response) or turn the
switch towards (
_
) for less sensitivity
(slower response).
Switch
Higher sensitivity
Less sensitivity
Center
position
Driving Your Mazda
Switches and Controls
5-51
Mazda5_8W75-EA-06J_Edition1 Page159
Thursday, October 12 2006 5:11 PM
Form No.8W75-EA-06J
To Next Page
Loading...
