Black plate (161,1)
NOTE
l
The auto-wiper contr ol may not
operate when the rain sensor
temperature is about
_
10 °C(14 °F)
or lower, or about 85 °C(185 °F) or
higher.
l
If the windshield is coated with
water repellent, the rain sensor may
not be able to sense the amount of
rainfall correctly and auto-wiper
control may not operate properly.
l
If dirt or foreign matter (e.g. ice or
matter containing salt water) adheres
to the windshield above the rain
sensor or if the windshield is iced, it
could cause the wipers to move
automatically. However, if the wipers
cannot remove this ice, dirt or
foreign matter, the auto-wiper
control will stop operation. In this
case, pull the wiper lever to the 1 or
2 position for manual operation, or
remove the ice, dirt or foreign matter
by hand to restore the auto-wiper
operation.
qWindshield Washer
Pull the lever toward you and hold it to
spray washer fluid.
OFF
Washer
NOTE
With the wiper lever in the OFF or INT
(Type A)/AUTO (Type B) position, the
wipers will operate continuously until
the lever is released.
If the washer doesn't work, inspect the
fluid level (page 8-25). If it's OK, consult
an Authori zed Mazda Dealer.
Driving Your Mazda
Switches and Controls
5-53
Mazda5_8W75-EA-06J_Edition1 Page161
Thursday, October 12 2006 5:11 PM
Form No.8W75-EA-06J
To Next Page
Loading...
