Mazda 5 - Page 260

Black plate (260,1)
NOTE
l
Some Bluetooth
®
audio devices need a
certain amount of time before the “
”
symbol is displayed.
l
If the programming failed, “Err” flashes
for three seconds then it returns to
“PAIR DEVICE”.
l
Programming cannot be performed while
the vehicle is moving. If you attempt to
perform programming while the vehicle is
moving, “PAIR DISABLE” is displayed and
it returns to “PAIR DEVICE”.
l
If seven Bluetooth
®
audio devices have
already been programmed to the vehicle,
programming cannot be performed and
“MEMORY FULL” is displayed. Delete
one programmed device to program
another one.
Programming a Bluetooth
®
audio
device which does not have a four-digit
PIN code
1. Using the audio control dial, select the
pairing program mode
“PAIR DEVICE” in the “BT SETUP”
mode. (Refer to “Bluetooth
®
audio set
up” for details.)
2. Press the audio control dial to
determine the mode.
After “ENTER PIN” is displayed on
the information displ ay for three
seconds, “PIN 0000” is displayed and
the PIN code can be input.
3. Press the audio control dial while
“PIN 0000 ” is displayed.
“PAIRING” flashes on the display.
4. Operate the Bluetooth
®
audio device
and set it to the progra m mode while
“PAIRING” is flashing.
5. As the Bluetooth
®
audio device
requires a PIN code, input “0000”.
6. When the programming is completed,
“
” and “PAIR SUCCESS” are
displayed after about 10-30 seconds,
after which “PAIR SUCCE SS”
continues to be displayed for three
seconds, and then the unit returns to the
normal display.
NOTE
l
If pairing cannot be completed, try “1234”
instead. Refer to the owner's manual of
your mobile device for the right PIN code.
l
Some Bluetooth
®
audio devices need a
certain amount of time before the “
”
symbol is displayed.
l
If the programming failed, “Err” flashes
for three seconds then it returns to
“PAIR DEVICE”.
l
Programming cannot be performed while
the vehicle is moving. If you attempt to
perform programming while the vehicle is
moving, “PAIR DISABLE” is displayed and
it returns to “PAIR DEVICE”.
l
If seven Bluetooth
®
audio devices have
already been programmed to the vehicle,
programming cannot be performed and
“MEMORY FULL” is displayed. Delete
one programmed device to program
another one.
6-64
Interior Comfort
Bluetooth® Audio
Mazda5_8FA7-EA-15G_Edition3 Page260
Friday, December 4 2015 8:27 AM
Form No.8FA7-EA-15G