Black plate (97,1)
4. Slide the retainer bar in the direction
indicated in the figure, and engage the
anchors into the seatback retainers.
Retainer bar
5. Slowly pull out the net in the upward
direction, insert the left and right net
anchors into the ceiling retainers, and
slide them to the position indicated in
the figure.
Net
anchor
Net
To remove the net:
1. Lift the net slightly and disengage the
net anchors from the ceiling retainers .
2. Slowly lower and support the net as it
rolls up into the retainer bar.
3. Remove the retainer bar in the reverse
order of installation.
CAUTION
When disengaging the net anchors, hold
the top of the net firmly in your hand. If
you lose control of the net, it will
automaticall y roll up in an uncontroll ed
manner and could cause injury.
Knowing Your Mazda
Doors and Locks
3-19
Mazda6_8U66-EA-05F_Edition1 Page97
Friday, June 3 2005 8:46 AM
Form No.8U66-EA-05F
To Next Page
