Black plate (458,1)
5. Remove the metal stiffeners from each
blade rubber and install them in the
new blade.
CAUTION
Ø Do not bend or discard the
stiffeners. You need to use them
again.
Ø If the metal stiffeners are
switched, the blade's wiping
efficiency could be reduced.
So do not use the driver's side
metal stiffeners on the passenger's
side, or vice versa.
Ø Be sure to reinstall the metal
stiffeners in the new blade rubber
so that the curve is the same as it
was in the old blade rubber.
6. Carefully insert the new blade rubber.
Then install the blade assem bly in the
reverse order of removal.
6-36
Maintenance and Care
Owner Maintenance
Mazda6_8EA2-EA-14K_Edition5 Page458
Friday, November 27 2015 5:0 PM
Form No.8EA2-EA-14K
To Next Page
