Maintenance
8-50
NOTE
If
the bulb is accidentally touched, it
should
be cleaned with rubbing
alco
-
hol before being used.
Do not remove the burned-out bulb
unless
you can immediately replace it
with
a new one. If a bulb is removed
for
an extended period of time,
con
-
taminants may enter the headlight
housing and affect its performance.
1. Make sure the headlight control
switch is in the OFF position.
2. Open the hood. If you are replacing
the driver side headlight, unclip the
electronic
module on the right side
of
the
battery and move
it out of the way
.
3. Locate
the headlight bulb through the
hole in the upper radiator support
assembly.
4. Disconnect the electrical connector
from the bulb by pulling rearward.
5. Remove the bulb retaining ring by
rotating it counterclockwise (when
viewed from the rear) to free it from
the
bulb socket, and slide the ring of
f
the
plastic base.
Keep the ring in the
rearward position. You must use it
again to hold the new bulb in place.
6. Carefully remove the bulb assembly
from
its connector by gently pulling it
rearward without turning.
To Next Page
Loading...
