Mazda B2300 2001 - Page 77

Knowing Y our Mazda
3-15
4. Turn the ignition to OFF and remove
the second SecuriLockT key from
the ignition.
5. Within 10 seconds of turning the
ignition to OFF, insert the unpro-
grammed SecuriLockT key (new
key/valet key) into the ignition and
turn the ignition from OFF to ON
(maintain ignition in ON for at least
one second). This step will program
your new SecuriLockT key.
6. To
program additional SecuriLock T
key(s), repeat this procedure from
step 1.
If the programming procedure was suc-
cessful, the new SecuriLockT key(s)
will start the vehicle’s engine. The
THEFT
indicator (located on the instru -
ment
cluster) will light for three seconds
and then go out.
If the programming procedure was not
successful,
the new SecuriLock T key(s)
will not operate the vehicle’s engine.
The THEFT indicator will flash on
and off. Wait at least one minute and
then repeat the procedure from step 1.
If failure repeats, bring your vehicle
to your dealership to have the spare
SecuriLockT key(s) programmed.