For the purposes of safety, switch the MRCC system o when it is not being used.
CAUTION
If the vehicle is towed or you are towing something, switch the MRCC system o to prevent an
incorrect operation.
NOTE
•
The MRCC system operates when all of the following conditions are met.
•
The vehicle speed is about 30 km/h (19 mph) to 145 km/h (90 mph).
•
The MRCC system is turned on.
•
The parking brake is not applied.
•
The Smart Brake Support (SBS) is not malfunctioning.
•
The Dynamic Stability Control (DSC) is operating normally.
•
All doors are closed.
•
The driver's seat belt is fastened.
(Manual transaxle)
•
The shift lever is in a position other than reverse (R) or neutral (N).
•
The clutch pedal is not depressed.
(Automatic transaxle)
•
The selector lever is in the drive (D) position or manual (M) position (manual mode).
•
In the following cases, the warnings may not activate even if your vehicle starts closing in
on the vehicle ahead.
•
You are driving at the same speed as the vehicle ahead.
•
Directly after the MRCC system has been set.
•
When the accelerator pedal is depressed or directly after the accelerator pedal is
released.
•
Another vehicle cuts into the driving lane.
•
The following are not detected as physical objects.
•
Vehicles approaching in the opposite direction
•
Pedestrians
•
Stationary objects (stopped vehicles, obstructions)
•
If a vehicle ahead is traveling at an extremely low speed, the system may not detect it
correctly.
•
During headway control travel, do not set the system on two-wheeled vehicles such as
motorcycles and bicycles.
•
Do not use the MRCC system under conditions in which the close proximity warnings are
frequently activated.
When Driving
i-ACTIVSENSE
4-96
CX-3_8GA5-EA-17F_Edition1 2017-4-7 15:30:54
To Next Page
