▼
To Temporarily Cancel
To temporarily cancel the system, use one
of these methods:
•
Slightly depress the brake pedal.
•
(Manual transaxle)
Depress the clutch pedal.
•
Press the OFF/CAN switch.
If the RES/
switch is pressed when the
vehicle speed is 25 km/h (16 mph) or
higher, the system reverts to the previously
set speed.
NOTE
•
If any of the following conditions occur,
the cruise control system is temporarily
canceled.
•
The parking brake is applied.
•
(Automatic transaxle)
The selector lever is in the P or N
position.
•
(Manual transaxle)
The shift lever is in the neutral
position.
•
When the cruise control system is
temporarily canceled by even one of the
applicable cancel conditions, the speed
cannot be re-set.
•
(Automatic transaxle)
The cruise control cannot be cancelled
while driving in manual mode (selector
lever shifted from D to M position).
Therefore, engine braking will not be
applied even if the transaxle is shifted
down to a lower gear. If deceleration is
required, lower the set speed or depress
the brake pedal.
▼
To Deactivate
When a cruising speed has been set
(cruise set indication (white) is
displayed/cruise set indicator light
(green) turns on)
Long-press the OFF/CAN switch or press
the OFF/CAN switch 2 times.
When a cruising speed has not been set
(cruise main indication (white) is
displayed)
Press the OFF/CAN switch.
When Driving
Cruise Control
4-125
CX-3_8GA5-EA-17F_Edition1 2017-4-7 15:30:54
To Next Page
