DTC C1031:54 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2906900.html[1/7/13 9:30:05 AM]
< Previous Next >
2013 - CX-5 - Brakes
DTC C1031:54 [DYNAMIC STABILITY CONTROL (DSC)]
DTC C1031:54 Tire pressure monitoring system (TPMS) system
DETECTION
CONDITION
Detects that tire such as temporary spare tire with outer diameter of
considerable difference is installed
There is a large fluctuation in steering angle and
acceleration/deceleration speed repeatedly over short intervals.
FAIL-SAFE
FUNCTION
Tire pressure monitoring system warning light illuminates after flashes.
Inhibits the TPMS control.
POSSIBLE CAUSE
Diameter of currently installed tires differs from Mazda recommended
tires
There is a large fluctuation in steering angle and
acceleration/deceleration speed repeatedly over short intervals.
DSC HU/CM malfunction
SYSTEM WIRING
DIAGRAM
—
Diagnostic procedure
STEP INSPECTION ACTION
1
VERIFY THE TIRE
Verify that the currently equipped tire
type (size, supplier, and type) conform
to the Mazda recommendation.
(See
WHEEL AND TIRE SPECIFICATION.)
Is the tire type as specified?
Yes Go to the next step.
No Replace the tire, then go to Step 3.
(See
WHEEL AND TIRE SPECIFICATION.)
2
MEASURE THE TIRE PRESSURE
Measure the tire pressure when the tires
are cold.
WHEEL AND TIRE SPECIFICATION
Yes Go to the next step.
No Adjust the tire pressure to the
specification when the tires are cold,
To Next Page
Loading...
Need help?
General
