the wiper arm tab to remove the blade
component from the wiper arm.
3. Pull the blade rubber in the direction of
the arrow and slide it to a position
where the blade holder groove can be
checked.
Groove
4. Pull the end of the blade rubber from
the blade holder groove in the direction
of the arrow and remove the blade
rubber from the blade holder.
Groove
5. Insert the end of the new blade rubber
into the groove of the blade holder
Maintenance and Care
Owner Maintenance
6-35
CX-5_8JM9-EA-20G_Edition1_old 2020-6-2 16:33:11
To Next Page
Loading...
