▼
Locking, Unlocking with Touch
Sensor, Door Handle (With the
advanced keyless function)
By touching the sensing area of the
touch sensor, various locking/
unlocking operations can be done
without taking the key out of a bag or
pocket.
There are two types of touch sensors
used for locking and unlocking, and
each sensor is built into the outer door
handle on the driver and front
passenger's doors.
1. Sensing area of door lock touch
sensor (Depression on outer side of
door handle)
2. Sensing area of door release touch
sensor (Inner side of door handle)
NOTE
x
When locking/unlocking with the
transmitter carried, securely touch
the sensing area of the touch sensor
as follows.
Locking
Unlocking
x
The system may not operate normally
under the following conditions.
x
You touch the sensing area of the
door lock touch sensor and the
sensing area of the door release
touch sensor at the same time.
x
You touch the sensing area of the
touch sensor while wearing gloves.
x
Foreign matter such as snow or dirt
is stuck on the sensing area of the
touch sensor.
x
You pull the door handle just after
touching the sensing area of the
touch sensor.
x
The system may operate if the outer
side door handle of a front door is
splashed with water by a car wash or
rain while the transmitter is in the
operation range.
x
If the system does not operate even
though you touch the sensing area of
the touch sensor correctly, release
the touch sensor once, and then
touch the sensing area of the touch
sensor again after waiting about 3
seconds.
Locking
When locking, touch the sensing area
of the door lock touch sensor with all
of the following conditions met.
x
The power switch is switched OFF.
x
All the doors are closed.
x
You are carrying the transmitter.
The following locations are locked by
touching the sensing area of the door
lock touch sensor.
Before Driving
Doors and Locks
3-42
To Next Page
Loading...
