The system will be triggered again (up
to 10 times) if one of the above
conditions remains.
x
Disconnecting the lead-acid battery
terminal (the hazard warning lights
do not flash).
The system will be triggered about 10
times.
Without the intrusion sensor
x
Unlocking a door with the auxiliary
key, door lock switch, or an inside
door-lock knob.
x
Forcing open a door, the bonnet or
the liftgate.
x
Opening the bonnet by operating
the bonnet release handle.
x
Switching the power switch ON
without using the power switch.
If the system is triggered again, the
lights and horn will activate until the
driver's door or the liftgate is unlocked
with the transmitter.
NOTE
x
The liftgate does not open while the
theft-deterrent system is operating.
x
If the lead-acid battery goes dead
while the theft-deterrent system is
armed, the siren/horn will activate
and the hazard warning lights will
flash when the lead-acid battery is
charged or replaced.
▼
How to Arm the System
1. Close the windows and the
sunroof
*
securely.
NOTE
(With the intrusion sensor)
Even with a window or the sunroof
*
open, the system can be armed,
however, leaving the windows or
the sunroof
*
even partially open can
invite theft, and wind blowing into
the vehicle could trigger the alarm.
The intrusion sensor function can
also be cancelled.
Refer to Cancelling the Intrusion
Sensor (With Intrusion Sensor) on
page 3-66.
2. Switch the power switch OFF.
3. Make sure the bonnet, the doors,
and the liftgate are closed.
4. Press the lock button on the
transmitter.
The hazard warning lights will flash
once.
Before Driving
Security System
*Some models.
3-65
To Next Page
Loading...
