¾If the wipers are operated while the
glass is dry, the glass could be
scratched and the wiper rubber
damaged. When the glass is dry,
spray washer fluid before operating
the wipers.
¾If the amount of washer fluid spray is
insucient, do not use the washer
switch. If the washer switch
continues to be operated with no
washer fluid being sprayed, it could
lead to pump damage.
NOTE
If the windscreen wipers are operated
under cold weather conditions or
during snowfall, they could stop due to
accumulated snow on the windscreen.
If the windscreen wipers stop due to
accumulated snow on the windscreen,
park the vehicle in a safe place, turn
the wiper switch o, and then remove
the accumulated snow. If the wiper
switch is turned to another position
other than OFF, the wipers will
operate. If the wipers do not operate
even though the wiper switch is turned
to a position other than OFF, consult
an expert repairer (we recommend an
Authorised Mazda Repairer) as soon as
possible.
▼
Windscreen Wipers
Turn the wipers on by pressing the
lever up or down.
1. Indicator light
Switch Posi-
tion
Wiper operation
Operation while pulling up
lever
OFF Stop
AUTO
*1
Auto control
Low speed
High speed
*
1 When the wiper lever is switched to the
AUTO position, the indicator light turns on.
Auto-wiper control
When the wiper lever is in the AUTO
position, the rain sensor senses the
amount of rainfall on the windscreen
and turns the wipers on or o
automatically
(o
ʊintermittentʊlow
speedʊhigh speed).
When Driving
Switches and Controls
4-45
To Next Page
Loading...
