Mazda MX-30 2020 - Page 326

¾Consult an expert repairer (we
recommend an Authorised Mazda
Repairer) for repair, painting, or
replacement of the front/rear
camera, front bumper, liftgate and
door mirrors.
¾Heed the following cautions to
assure that the 360°View Monitor
operates normally.
¾Do not modify the vehicle
suspensions or lower/raise the
vehicle body, or both.
¾Always use tyres of the
specified
type and size for the front and rear
wheels. Consult an expert repairer
(we recommend an Authorised
Mazda Repairer) for tyre
replacement.
¾When the display is cold, images
may leave trails or the screen might
be darker than usual, making it
dicult to check the vehicle
surroundings. Always
confirm
the
safety at the front and around the
vehicle visually when driving.
¾The method for parking/stopping
the vehicle using the 360°View
Monitor
diers
depending on the
road circumstances/conditions and
the vehicle conditions. When and
how much you turn the steering
wheel will dier depending on the
situation, , therefore always check
the vehicle surroundings directly with
your eyes while using the system.
Also, before using the system, always
make sure that the vehicle can be
parked/stopped in the parking/
stopping space.
NOTE
x
If there are water droplets, snow, or
mud on the camera lens, wipe it o
using a soft cloth. If the camera lens
is especially dirty, wash it o with
mild detergent.
x
If the camera lens is touched or there
is any dirt on it, it could aect the
screen image. Wipe the lens using a
soft cloth.
x
If the area where the camera is
installed, such as the front bumper,
liftgate or door mirrors, has been
damaged in a vehicle accident, the
camera (position, installation angle)
may have shifted. Always consult an
expert repairer (we recommend an
Authorised Mazda Repairer) to have
the vehicle inspected.
x
If the camera is subjected to
excessive changes in temperature
such as by pouring hot water on the
camera during cold weather, the
360°View Monitor may not operate
normally.
x
If the vehicle is driven during cold
temperatures and the camera
temperature decreases, the top view
and the side view may become
unclear. However, this does not
indicate a problem. If the vehicle is
stopped for a while and the camera
temperature increases, the top view
and the side view will return to the
normal condition.
x
If the lead-acid battery voltage is
low, the screen might be temporarily
dicult to view, however, this does
not indicate a problem.
x
The 360°View Monitor has
limitations. Objects under the
bumper or near both ends of the
bumper cannot be displayed.
x
Obstructions above the upper image
range of the camera are not
displayed.
When Driving
i-ACTIVSENSE
4-159