13.Install the compressor hose to the
tyre valve.
1. Valve
2. Compressor hose
14.Insert the compressor plug into the
interior accessory socket and switch
the power switch ACC (page 5-37).
1. Compressor
2. Compressor plug
CAUTION
¾Before pulling out the compressor
plug from the electrical socket,
make sure the compressor power
switch is
o.
¾The compressor turns on and o
with the push-button switch.
15.Turn the compressor switch on and
inflate the tyre carefully to the
correct
inflation
pressure.
WARNING
Never operate the compressor
above 300 kPa (3.1 kgf/cm
2
, 3
bar, 43.5 psi):
Operating the compressor above
300 kPa (3.1 kgf/cm
2
, 3 bar, 43.5
psi) is dangerous. When the
inflation
pressure rises above 300
kPa (3.1 kgf/cm
2
, 3 bar, 43.5 psi),
heated air will be exhausted from
the back of the compressor and you
could be burned.
NOTE
x
Check the tyre inflation pressure
label (rear door on the driver's
side) for the correct tyre inflation
pressure.
x
Do not use the compressor for
longer than 10 minutes because
using the compressor for long
periods could damage it.
If Trouble Arises
Flat Tyre
7-19
To Next Page
Loading...
