3. Remove the cover of the
child-restraint system's ISOFIX
anchors to verify the locations of
the ISOFIX anchors.
1. ISOFIX anchor
NOTE
x
The ISOFIX anchors marking on
the cover indicates the position of
the ISOFIX anchors for the
attachment of a child-restraint
system.
x
Store the removed cover so that it
does not get lost.
4. Remove the head restraint.
However, when installing a booster
seat, always install the vehicle head
restraint to the seat where the
booster seat is installed.
Refer to Head Restraints on page
2-19.
5. Secure the child-restraint system
using the ISOFIX anchor, following
the child-restraint system
manufacturer's instruction.
6. If your child-restraint system came
equipped with a tether, that
probably means it is very important
to properly secure the tether for
child safety. Please carefully follow
the child-restraint system
manufacturer's instructions when
installing tethers (page 2-45).
WARNING
Always attach the tether strap to the
correct tether anchor position:
Attaching the tether strap to the
incorrect tether anchor position is
dangerous. In a collision, the tether
strap could come o and loosen the
child-restraint system. If the
child-restraint system moves it could
result in death or injury to the child.
Always remove the head restraint and
set the tether strap (except when
installing a booster seat):
Routing the tether strap on top of the
head restraint is dangerous. In a
collision the tether strap could slide o
the head restraint and loosen the
child-restraint system. The
child-restraint system could move
which may result in death or injury to
the child.
1. Tether strap
2. Anchor bracket
3. Forward
Essential Safety Equipment
Child Restraint
2-47
To Next Page
Loading...
