cause damage to fuel pipe and quick release connector. Always clean quick release
connector joint area before disconnecting/connecting, and make sure that it is free of
foreign material.
Diagnostic procedure
STEP
INSPECTION
RESULTS
ACTION
Yes
Both conditions appear:
Go to Step 4.
1
Connect the WDS or equivalent to the
DLC-2.
Do the following conditions appear?
• The engine is not completely
started.
• DTC B1260 is displayed.
No
Either or other condition
appears:
Go to the next step.
Yes Go to the next step.
2
Are the ignition coil connectors securely
connected to the coil?
No
Connect the coil connectors
securely.
Return to Step 1.
Yes Go to the next step.
3 Does the security light illuminate?
No
Inspect the instrument cluster and
the following wiring harnesses.
• Between PCM terminal 4V
and instrument cluster
terminal 1J
• Between PCM terminal 4S
and instrument cluster
terminal 1L
Yes
Go to the applicable DTC
inspection.
(See DTC TABLE
(IMMOBILIZER SYSTEM) .)
(See DTC TABLE [MULTIPLEX
COMMUNICATION SYSTEM]
.)
4
Connect the WDS or equivalent to the
DLC-2 and retrieve DTC.
Are any of the following DTCs displayed?
DTC
o B1213, B1341, B1600, B1601,
B1602, B1681, B2103, B2139,
B2431, U1147, U2510
No Go to the next step.
(w) RX8-Engine Troubleshooting
Page 19
To Next Page
