1. Connect the WDS or equivalent to the DLC-2 if you are inspecting sensors or switches.
2. Turn the ignition switch to the ON position (Engine off).
NOTE:
• If the engine starts and runs, perform the following steps at idle.
3. Access the PIDs for sensors or switches if you are inspecting sensors or switches.
4. If you are inspecting the switch, turn it on manually.
5. Spray water onto the vehicle or run it through a car wash.
• If the PID value is unstable or malfunction occurs, repair or replace the part if necessary.
(w) RX8-Engine Troubleshooting
Page 5
To Next Page
Loading...
