LIGHT SWITCH
LIGHT SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the column cover.(See COLUMN COVER REMOVAL/INSTALLATION .)
3. Remove the ignition key illumination.(See IGNITION KEY ILLUMINATION BULB
REMOVAL/INSTALLATION .)
4. Disconnect the connector.
5. Remove the screws and then remove the light switch.
6. Install in the reverse order of removal.
LIGHT SWITCH INSPECTION
1. Remove the column cover.(See COLUMN COVER REMOVAL/INSTALLATION .)
2. Remove the ignition key illumination.(See IGNITION KEY ILLUMINATION BULB
REMOVAL/INSTALLATION .)
3. Remove the light switch.(See LIGHT SWITCH REMOVAL/INSTALLATION .)
To Next Page
Loading...
