DRL CONTROL MODULE INSPECTION
1. Connect the connector to the DRL control module.
2. Connect the negative battery cable.
3. Measure the voltage at the DRL control module using voltmeter.
• When inspecting terminal 1B, 1D or 2D for continuity, disconnect the DRL control module
connector.
4. If the value are not as specified in the Terminal Voltage List (Reference), inspect the parts under
"Inspection item(s)" and related wiring harnesses.
5. If the system does not work properly even though the parts or related wiring harnesses do not have any
malfunction, replace the DRL control module.
To Next Page
Loading...
