CAR-NAVIGATION UNIT
CAR-NAVIGATION UNIT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the console.(See CONSOLE REMOVAL/INSTALLATION .)
3. Remove in the order indicated in the table.
1 Connector
2 Bolt
3 Car-navigation unit
4. Install in the reverse order of removal.
CAR-NAVIGATION SYSTEM DIAGNOSIS SCREEN INFORMATION
1. Select "SET UP MENU".
2. Select "SYSTEM INFORMATION".
3. Select "VERSION".
4. Press the joystick up 2 times , then down 2 times .
5. Select one of two menus "WIRING CHECK" or "GPS".
• WIRING CHECK
Speed (MPH)
ACC voltage
Speed pulse
Accuracy level
• GPS
To Next Page
Loading...
