o 1.8 ohms
2. Connect a 1.5 V battery to the center speaker and verify that sound is output from the center speaker.
• If no sound is output, replace the center speaker.
REAR TWEETER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Rear seat(See REAR SEAT REMOVAL/INSTALLATION .)
b. Console(See CONSOLE REMOVAL/INSTALLATION .)
c. Tire house trim(See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
d. Rear pillar trim(See REAR PILLAR TRIM REMOVAL/INSTALLATION .)
e. Rear package side trim(See REAR PACKAGE TRIM REMOVAL/INSTALLATION .)
3. Remove in the order indicated in the table.
1 Screw
2 Rear tweeter
4. Install in the reverse order of removal.
REAR TWEETER INSPECTION
1. Verify that sound is output from the rear speaker.
• If sound is output, go to the next step.
• If no sound is not output, inspect the rear speaker and the related wiring harnesses.
2. Remove the main amplifier.(See AUDIO AMPLIFIER REMOVAL/INSTALLATION .)
3. Verify that the continuity between the rear tweeter and the main amplifier is as indicated in the table.
• If not as indicated in the table, repair or replace the related wiring harnesses.
• If as indicated in the table, replace the rear tweeter.
To Next Page
Loading...
