Mazda RX8 - Page 256

CONDENSER
CONDENSER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Rear seat(See REAR SEAT REMOVAL/INSTALLATION .)
b. Console(See CONSOLE REMOVAL/INSTALLATION .)
c. Tire house trim(See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
d. Rear pillar trim(See REAR PILLAR TRIM REMOVAL/INSTALLATION .)
e. Rear package center trim, rear package side trim(See REAR PACKAGE TRIM
REMOVAL/INSTALLATION .)
3. Remove in the order indicated in the table.
1 Bolt
2 Connector
3 Condenser
4. Install in the reverse order of removal.
(w) RX-8 Body
Page 256