KEYLESS CONTROL MODULE CONFIGURATION
1. Connect the WDS or equivalent to the DLC-2.
2. Select "Module programming" from the menu.
3. Select "Programmable Module Installation".
4. Select "RKE" from the menu and perform procedure according to the directions on the WDS or
equivalent screen.
KEYLESS RECEIVER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
3. Remove the bolts.
4. Remove the connector clip installed to the bracket by shifting the keyless receiver downward.
5. Disconnect the keyless receiver connector.
To Next Page
Loading...
