3. Verify that the security light illuminates for approx. 3 s and then goes out.
4. Using key 1, turn the ignition switch to the LOCK position within approx. 4 s after the security light
goes out.
5. Remove key 1
6. Repeat Steps 25 using key 2.
7. Repeat Steps 25 using key 3.
8. If additional keys need to be registered, repeat Steps 17 in the same manner as key 3.
No.2 Additional Key Registration Procedure (Using the WDS or Equivalent)
Conditions
• Customer has only one valid key. Or customer has no valid keys. (Can also be performed even if there
are two or more valid keys)
NOTE:
• A maximum of eight keys can be registered for any one vehicle. If key registration is not successful and
DTC 15 appears even though the procedure was performed properly, use the WDS or equivalent and
verify the number of keys that have been registered.
• If eight keys have already been registered, and it is necessary to register other keys, the previously
registered key ID numbers must first be cleared. Perform key ID number clearing according to " No.3
Key Replacement Procedure (Clearing Previously Registered Key ID Numbers, Key Re-registration) ".
Procedure
1. Have one key (key 1) ready for registration.
2. Using key 1, turn the ignition switch to the ON position.
To Next Page
Loading...
