NOTE:
• Although the security light flashes and DTC 15 is displayed, this does not indicate an improper
procedure. Continue to perform the procedure as indicated.
3. Connect the WDS or equivalent to the DLC-2.
4. Select "Body/Security/PATS function" from the screen menu of the WDS or equivalent.
5. Perform security access as indicated on the WDS or equivalent screen. (See No.6 Security Access
Procedure .)
6. Select "Program Additional Ignition Key" from the screen menu of the WDS or equivalent.
NOTE:
• After selecting this menu, "Successful" appears on the WDS or equivalent screen. When this
occurs, registration is completed for the key turning the ignition switch to the ON position.
• If the necessary number of keys have been registered, the additional key registration procedure is
completed with this step. Go to Step 10.
• If additional keys need to be registered, go to the next step.
7. After verifying that the PATS function menu is displayed again on the WDS or equivalent screen, turn
the ignition switch to the LOCK position and remove key 1.
8. Using an additional key requiring registration, turn the ignition switch to the ON position.
9. Return to Step 6.
10. After verifying that the PATS function menu is displayed again on the WDS or equivalent screen, select
"Exit" to complete the WDS or equivalent function.
11. After Step 10, wait 10 s or more and turn the ignition switch to the LOCK position.
To Next Page
Loading...
