Mazda RX8 - Page 85

10. Install the following parts:
. Map light(See MAP LIGHT REMOVAL/INSTALLATION .)
a. Sunvisor(See SUNVISOR REMOVAL/INSTALLATION .)
b. A-pillar trim(See A-PILLAR TRIM REMOVAL/INSTALLATION .)
c. Rearview mirror(See REARVIEW MIRROR REMOVAL/INSTALLATION .)
d. Cowl grille(See COWL GRILLE REMOVAL/INSTALLATION .)
e. Windshield wiper arm and blade(See WINDSHIELD WIPER ARM AND BLADE
REMOVAL/INSTALLATION .)
11. Allow the sealant to harden completely.
o Sealant hardening time: 24 h
REAR WINDOW GLASS REMOVAL
1. Remove the following parts:
a. Rear seat (See REAR SEAT REMOVAL/INSTALLATION .)
b. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
c. Rear pillar trim (See REAR PILLAR TRIM REMOVAL/INSTALLATION .)
d. Rear package trim (See REAR PACKAGE TRIM REMOVAL/INSTALLATION .)
2. Remove the nut.
(w) RX-8 Body
Page 85