c. Remove the remaining double-sided adhesive tape from the rear window molding, and install the
rear window molding (upper) to the rear window glass while aligning the molding with the
center of the marking on the glass.
NOTE:
• Double-sided adhesive tape has been affixed to the new rear window molding.
d. Install the rear window molding (lower).
e. Apply the glass primer to the inside of the rear window molding at the joint between the upper
and lower parts.
f. Affix the tape to the inside of the rear window molding at the joint.
g. Install the dam by aligning its end with the center of the marking on the glass as shown in the
figure.
To Next Page
Loading...
