13. Connect the antenna and the filament connectors.
14. Install the following parts:
. Rear package trim (See REAR PACKAGE TRIM REMOVAL/INSTALLATION .)
a. Rear pillar trim (See REAR PILLAR TRIM REMOVAL/INSTALLATION .)
b. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
c. Rear seat (See REAR SEAT REMOVAL/INSTALLATION .)
15. Allow the sealant to harden completely.
o Sealant hardening time: 24 h
16. Apply soapy water to the rear window molding side and blow air from the interior, then verify that there
are no bubbles or air leakage.
• If there are any bubbles or air leakage, repair the damaged part of the sealant and verify it again.
To Next Page
Loading...
