16
Assembly instructions
Pergola
13a. Place the middle beam D between the front and rear beams C, ensuring the
slat brackets are facing the same direction as the slat brackets on beams B1 and B2.
13b. Fix washer K3 with screw K2
and align with hole below beam
D. Do not overtighten screws K2
(this is completed once all slats
are fitted).
13c. Fix washer K3 with screw K2 and
align with hole on top beam D. Do not
overtighten screws K2 (this is completed
once all slats are fitted).
K2 QTY: 8PCS K3 QTY: 8PCS
To Next Page
Loading...
