13
unique high end audio
mbl 101 E MKII
spikes
screw nuts
brass washers
4.2 Placing the speaker cover
Carefully set the cover on the speaker.
Caution: One side of the cover is shorter. This side
must be on the back of the speaker.
Insert the 4 allen head screws (M4 x 50) in the
holes of the lower golden edges and slightly tight-
en them.
It is possible to use the cover without screws. Then,
no lateral force must be aected onto the cover.
cut-out on the back
4.1 Spikes
To adjust the bass response to your room you can
use the enclosed spikes.
If you prefer a strong bass, place the systems di-
rectly on a solid ground without using spikes.
To achieve a tighter bass with more impact,
screw the spikes into the speaker´s feet, so that
the speaker stands on the spikes. To protect your
floor it is recommended to use the enclosed brass
washers.
In case that the floor is covered with a thick car-
pet, the speaker does not stand firmly. Due to this
reason the bass may sound uncontrolled without
definition. Use the spikes to avoid this.
To Next Page
Loading...
