McCulloch Mac 110 - Page 5

WE STRONGLY RECOMMEND you do not attempt to
operate the saw while IN A TREE, ON A LADDER or
ON ANY OTHER UNSTABLE SURFACE. If you elect
to do so, be advised that these positions are
EXTREMELY DANGEROUS. ®
DON'T CUT IN AWKWARD POSITIONS (off-balance,
out-stretched arms, one-handed, etc.).
WHEN CUTTING A LIMB THAT IS UNDER TENSION
be alert for springback so that you will not be struck
when the tension is released. ®
USE EXTREME CAUTION when cutting small size
brush and saplings because slender material may
catch the saw chain and be whipped toward you, or
pull you off balance. ®
VIBRATION - Avoid prolonged operation of your
chain saw and rest periodically, especially if your
hands or arms start to have a loss of feeling, swell or
become difficult to move. These conditions can
If ,M"' ~.
rJ '
~,
.j
reduce your ability to control a saw.
EXHAUST FUMES - Do not operate your chain saw
in confined or poorly vented areas.
OBSERVE ALL LOCAL FIRE PREVENTION REGULA-
TIONS. We recommend that you keep a fire
extinguisher and shovel close at hand whenever you
cut in areas where dry grass, leaves or other flam-
mable materials are present.
NOTE: Spark arrester screens are available for
installation in your muffler where fire regulations
require them. Check local regulations for your
-special requirements.
NEVER OPERATE YOUR CHAIN SAW WITHOUT A
MUFFLER.
DO NOT CARRY THE SAW BY THE CHAIN BRAKE
LEVER.
WHEN TRANSPORTING YOUR CHAIN SAW, use the
appropriate guide bar scabbard.
TURN OFF YOUR SAW WHEN MOVING BETweEN
CUTS and before setting it down. Always carry the
chain saw with the engine stopped, the guide bar
and saw chain to the rear, and the muffler away from
your body. @>
DON'T TOUCH or try to stop a moving chain with
your hand. @
DON'T ALLOW ANY OTHER PERSON or ANIMAL
CLOSE to a running saw or where a tree is being cut
down. @
/ DON'T TOUCH or let your hand come in contact with
a hot muffler, spark arrester, or a spark plug wire.
Don't ru n the saw without a muffler, exhaust stack,
or a spark arrester. Keep screens and baffles clean.@
KEEP THE CHAIN SHARP and SNUG on the GUIDE
bar. @
DON'T ALLOW DIRT, FUEL or SAWDUST to build up
on the engine or outside of the saw.
KEEP ALL SCREWS and FASTENERS TIGHT. Never
operate a chain saw that is damaged, improperly
adjusted, or is not completely and securely assem-
bled. Be sure that the saw chain stops moving when
the throttle control trigger is released. Keep the
handles dry, clean and free of oil or fuel mixture. @
DON'T OPERATE YOUR CHAIN SAW unless the
chain stops when the engine idles. (Have
corrected. )
5