To Next PageTo Next Page
Need help?Do you have a question about the McDonald Engineers POWER flow 2000 Series and is the answer not in the manual?
General| Model | POWERflow 2000 Series |
|---|---|
| Fuel Type | Electric |
| Voltage | 230V |
| Category | Water Heater |
| Type | Unvented |
| Power Rating | 3kW |
| Protection Rating | IPX4 |
Failure to install and maintain according to instructions invalidates the manufacturer's warranty.
Installation must be by a competent operative with recognized training in Unvented Hot Water Systems.
Handle unit with care, store upright, and ensure installation area supports unit weight and pipework.
Details on mains pressure, flux, PRV, check valves, and relief valves for proper installation.
Guidelines for Tundish placement, visibility, safety, and discharge pipework sizing and fall.
Instructions for connecting immersion heaters and wiring indirect units with zone valves and thermostats.
Steps for filling the cylinder, checking flow, ensuring watertightness, and verifying valve operation.
Verify thermostat settings, relief valve discharge, and overall system operation for safety.
Procedures for checking relief valves, strainer, and expansion vessel as part of annual service.
Immediate actions and safety precautions for overheated water discharge, including component checks.
Diagnosing water discharge issues and procedures for recharging the expansion vessel.
Troubleshooting immersion heater failure and other persistent system problems.
Wiring instructions for single and dual coil solar systems, including zone valve and thermostat connections.
Maintenance requirements for solar coil systems as per booklet and solar equipment dictates.
