LIMITED WARRANTY
This product is warranted to be free from defects in material and/
or workmanship for a period of two (2) years from date of original
installation, not to exceed 30 months from date of shipment from
our factory or 240,000 cycles. Any part or component which
proves to be faulty in material and/or workmanship within the
warranty period will be replaced or repaired (at the option of Prince
Castle, Inc.) without cost to the customer for parts or labor.
This warranty is subject to the following exceptions/conditions:
• Use of any non-genuine Prince Castle parts voids this
warranty and all work must be performed by an authorized
Prince Castle Service Agent.
• All labor shall be performed during regular work hours.
Overtime premium will not be covered.
• Travel charges are limited to 100 miles (200 kilometers) round
trip, 2 hours travel time, one trip per repair.
• Damage caused by carelessness, neglect, and/or abuse (e.g.,
using wrong current, dropping, tampering with or altering
electrical components, or improper cleaning) is not covered.
• Equipment damaged in shipment, by fire, flood or an act of
God is not covered.
• Damage to non-stick coated surfaces is not covered by this
warranty.
TABLE OF CONTENTS
Product Identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Important . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Installing New Riser and Rear Chute . . . . . . . . . . . . . . . . . . . 5
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Loading Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Operation Tips . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Adjustments/Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Management Programming . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Exploded Views and Parts Lists . . . . . . . . . . . . . . . . . . . . . . 17
Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Printed Circuit Board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Planned Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
Only use URT Cleaning Tool with a sanitized towel or blue non-scratch pad wrapped around the head of the cleaning
tool to clean the platens. Do NOT use anything abrasive because it will scratch the platens, which could cause bun
sticking. Do not use abrasive materials such as scrapers, steel wool, etc. to clean the Buffered Bun Landing Zone or
exterior of the unit, as damage to the surface could occur. Failure to follow the correct cleaning procedure or damage
to the platen due to scratches are not covered under the provisions of the warranty.
Do NOT use any unapproved agents or cleaning solutions inside or on the surfaces of the toaster unit.
To Next Page
General