Customer Helpline 0345 605 2062
14
Step 2 - Stopping
1. Release the trigger, and engage the safety lock.
2. Set the On/Off switch to OFF.
3. Close the water supply.
Step 3 – Use the high pressure lance
WARNING!
- Always turn off the machine when changing the high pressure lance.-The trigger gun is
subjected to a recoil force when the water jet is discharged. Make sure that you have a rm
footing and are also holding the trigger gun and spray lance with both hands.
1. Hold the hand-held spray lance and the jet tube rmly with both hands. Be aware of the
recoil when switching on the high-pressure jet.
2. Unlock the safety button and press the trigger on the handheld spray lance.
- It takes approximately 5 seconds to release the high pressure.
NOTE!
- Clogging of the spray tips causes the pump pressure to be too high and cleaning is immedi-
ately required. You can clean the spray tips by carefully inserting a using the supplied cleaning
pin into the tip to remove deposits.
Operate
To Next Page
Loading...
