Need help?Do you have a question about the McIntosh C40 and is the answer not in the manual?
General| Type | Preamplifier |
|---|---|
| Frequency Response | 20Hz to 20kHz |
| Total Harmonic Distortion | 0.002% |
| Signal-to-Noise Ratio | 100dB |
| Input Sensitivity (MM) | 2.5mV |
| Input Sensitivity (line) | 250mV |
| Signal to Noise Ratio (MM) | 80dB |
| Signal to Noise Ratio (line) | 100dB |
| Output (Pre out) | 2.5V |
| Output (Pre out Max) | 8V |
Details on frequency response, rated output, sensitivity, and signal-to-noise ratios for the preamplifier.
Specifications for equalizer controls, monitor amplifier power output, and AC power outlets.
Dimensions, weight, and finish details for the C40 audio control center.
Explanation of the C40's switching technology, phono preamplifier design, and input signal handling.
Details on the active loudness control circuit design and its compensation for listening levels.
Describes the signal flow for both listening and recording circuits, including processor integration.
Explains the Compandor's dynamic range control and the Monitor Amplifier's capabilities.
To Next Page
