EasyManua.ls Logo

McIntosh MB20 - Safety and Compliance Information; FCC Information (US Customers); IC Information (Canadian Customers); RED (EN) Information

McIntosh MB20
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Safety First
It is a smart idea to read all the enclosed
MB20 SAFETY INFORMATION
even if you already know this stu,
you can’t be too safe.
Here is some compliance information:
FCC Informaon
(US Customers)
1. IMPORTANT NOTICE: DO NOT MODIFY
THIS PRODUCT
This product, when installed as indicated in the instructions contained
in this manual, meets FCC requirements. Modication not expressly
approved by McIntosh may void your authority, granted by the FCC,
to use the product.
2. CAUTION:
To comply with FCC RF exposure compliance requirement,
separation distance of at least 20cm must be maintained between this
product and all persons.
• This product and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter.
3. COMPLIANCE INFORMATION:
• Product Name: MB20 Bluetooth Transceiver
• Model Number: MB20
• This product contains FCC ID:BWY-MB20
McIntosh Laboratory, Inc.
2 Chambers Street
Binghamton, NY 13903
Tel. (607) 723-3512
IC Informaon
(Canadian Customers)
1. PRODUCT:
This device contains license-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development
Canada’s license-exempt RSS(s). Operation is subject to the
following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including
interference that may cause undesired operation of the device.
2. CAUTION:
Under Industry Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that permitted for successful
communication.
This radio transmitter (IC: 2483A-MB20) has been approved by
Industry Canada to operate with the antenna types listed below with
the maximum permissible gain indicated.
Antenna types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use
with this device.
Antenna used by this product: MB20
Antenna Model: 380B
peak gain: 3dBi
Informaons sur IC (pour les
clients Canadiens)
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le
fonctionnement
RED (EN) Informaon
1.DECLARATION OF CONFORMITY
Our products follow the provisions of EC/EU directives:
LVD: 2014/35/EC
EMC: 2014/30/EU
RED: 2014/53/EU
ErP: EC regulation 1275/2008 and its frame work
directive 2009/125/EC
RoHS: 2011/65/EU
2. IMPORTANT NOTICE: DO NOT MODIFY
THIS PRODUCT
This product, when installed as indicated in the instructions contained
in this manual, meets RED directive requirements. Modication of
the product could result in hazardous Radio and EMC radiation.
3. CAUTION:
Separation distance of at least 20cm must be maintained between this
product and all persons.
This product and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter.