McIntosh ML1 - Page 14

14
Specications
System Driver Complement

One 2 inch soft dome Upper Midrange
Two 4 inch lower midranges

Impedance
8 ohms Nominal
Frequency Response
27Hz - 45,000Hz
Sensitivity

Crossover Frequencies
180Hz
500Hz
4500Hz
Recommended Power Range
75 Watts to 600 Watts
Maximum Power Handling
600 Watts
General Specications
Enclosure Finish

Grille Finish

cloth with aluminum trim
ML1 Dimensions



Stand Dimensions



ML1 Weight


Stand Weight


ML1 Shipping Carton Dimensions



Stand Shipping Carton Dimensions



Packing Instructions
In the event it is necessary to repack the equipment
for shipment, the equipment must be packed exactly
as shown below.
Use the original shipping carton and interior parts
only if they are all in good serviceable condition.

are needed, please call or write Customer Service
Department of McIntosh Laboratory. Refer to page
3. Please see the packing part lists on the following
page for the correct part numbers.