!
!
!
McIntosh MR85 Tuner LED Modification Instructions
1. Place unit upside down on a carpeted surface, with the front facing you.
!
2. Remove the three screws closest to the front panel that attach the bottom cover.
!
3. Turn the unit over and remove the six screws that attach the top cover. There are two on either side and two on the
rear. Slide the cover to the rear about ¼” and lift it straight up.
!
4. Remove the four screws (two on either side) that attach the front panel brackets. See fig. 1 and 2. Hold the front panel
while removing the screws to hold it steady. You may also have to cut a small nylon wire tie that secures the power leads
to the chassis. There may be a black ground wire on each side attached with these screws, if that is the case, just move
the wires to the side when the screws are removed. When all four screws are removed from the front panel, guide the
ribbon cables connecting it to the main chassis, and gently pull it toward you about 2 inches, and lay it down. .
Remember to replace them when re-assembling your MR85.
To Next Page
Need help?
General
