!
12. Very carefully, prop the front panel up against the chassis, taking care to not to crush any of the wires, and power-up
the MR85. Check to see that all LED’s are illuminating. If there are one or more that are not, remove power from the unit
and check all connections.
12. Now that you have everything working, you may re-assemble your MR85, by first re-attaching the front panel, making
sure not to crush any of the wires or ribbon cables. (Step 4) Don’t forget to attach the ground wire on each side.
!
13. Replace the nylon wire tie that was used to attach black wire cover to the chassis if removed.
!
14. Replace the three screws that attach the bottom cover to the front panel. (Step 2)
!
15. Position the top cover in place and replace the six screws that were removed in step 3.
!
16. You’re finished with the project. Reconnect your MR85 to the rest of your system, and enjoy the music!
!
PreludeAudio.com
127 Mohawk Avenue
Scotia, NY 12302
(518) 382-1411
Fax (518) 382-0210
Toll Free 866 828-2004
e-mail cable@preludeaudio.com
To Previous Page
Loading...
