TAPE MONITOR
PHASE
Figure 14 TAPE MONITOR Switch.
The TAPE MONITOR switch compares the
recorded tape with the program source.
When the TAPE MONITOR switch is in the
OUT position, the program source is heard
from the loudspeakers. When the TAPE
MONITOR switch is in the IN position, the
recorded tape is heard from the loudspeak-
ers. Jacks marked TAPE MONITOR are
located on the back panel. Plug a signal into
these jacks from a tape machine which has a
third head and a preamplifier for it. IMPOR-
TANT: When the TAPE MONITOR switch is
operated in the IN position, signal from any
other source will not be heard from the loud-
speakers. When not in use, make sure the
switch is in the OUT position.
Figure 15. PHASE Switch.
The PHASE switch corrects for loud-
speaker or program phasing. Placing this
switch in the 180° position reverses phase in
the left channel.
LEVEL SET CONTROLS
The MX110 LEVEL SET controls (see
figure 16 compensate for the difference in
output level from various program sources.
The output level of the FM tuner, for example,
is higher than the output of a magnetic pick-
up. When you switch from one program
source to another, the level will vary to an
annoying degree. The level controls can be
set so that the output levels of all program
sources are equal. The MX110 LEVEL SET
controls are located on top of the MX110
chassis behind the front panel.
9
To Next Page
Loading...
