McIntosh MX 110

MECHANICAL SPECIFICATIONS
DIMENSIONS
Chassis: 16 inches wide; 5 7 /, 6 inches high; 13
inches deep including connectors.
Front Panel: 16 inches wide; 5 7 /i« inches high.
Knob Clearance: 1 % inches.
FINISH
Anodized gold and black (front panel).
INSTALLATION
Convenient, professional PANLOC.
WEIGHT
Chassis: 27 % pounds.
Shipping Weight: 36 pounds.
TUNER SPECIFICATIONS
SENSITIVITY
Better than 2.5 microvolts at 100% modulation.
R.F. AMPLIFIER
Cascode.
I.F. AMPLIFIERS
Four.
LIMITERS
Two.
I.F. BANDWIDTH
200KC flat top.
I.F. TRANSFORMERS
Mechanically captive.
MUTING
I.F. injected.
TUNING INDICATOR
Tuning is indicated by an electron ray tube.
FREQUENCY RESPONSE
Within +1db 20 to 20,000 cycles. (Including 75
microseconds deemphasis.)
HUM
Greater than 70db or more below 100% mod.
(Audio tubes have D.C. on the filaments.)
DRIFT
Less than 25KC.
ANT. INPUT IMPEDANCE
300 balanced, 75 ohms unbalanced.
RADIATION
Substantially below F.C.C. requirements.
DISTORTION
Less than 0.6% distortion at 100% modulation,
+ 75KC deviation above 2.5 microvolts at antenna.
MULTIPLEX DECODER SPECIFICATIONS
MPX DECODER
Hum Level: Better than 60db below 100% stereo
modulation.
Distortion: Less than 0.3% (Multiplex Decoder only).
Channel Separation: Better than 30db at 1000 cps.
Suppression of Pilot (19KC), and Carrier (38KC):
Greater than 40db below 100% modulation.
Front Panel Stereo Indicator Light: Activated by
19KC pilot carrier only.
INPUTS
Total 5 each channel:
AUX.;
PHONO 1 MAG. or XTAL;
PHONO 2 MAG.;
TAPE HEAD;
TAPE MONITOR.
AUDIO SPECIFICATIONS
OUTPUTS
Main Stereo Outputs; 1 Tape Stereo Output;
1 L+R Output.
AC AUX OUTLETS
1 unswitched, 2 switched.
16