EasyManua.ls Logo

McIntosh MXA60 - Performance Specifications

McIntosh MXA60
42 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PERFORMANCE SPECIFICATIONS
2
SACD/CD Player Specications
Loudspeaker Specications
General Specications
AM Tuner Specications
Tuning Range
522kHz - 1602kHz (Europe)
530kHz - 1710kHz (USA)
522kHz - 1611kHz (Japan)
Antenna Input
RAA2 (supplied), Type “RJ45” connector
Sensitivity
350uV/m
Signal To Noise Ratio
50dB
Frequency Response
0dB, -6dB 50Hz to 3,000Hz
Harmonic Distortion
0.5%
Selectivity
45dB Adjacent Channel
Disc Formats
SACD, CD, MP3 and WMA
Transport
Laser Type: Twin Beam
Laser Beam Wavelength: 650nm (SACD)/790nm (CD)
Laser Power: CLASS IIa/CLASS I
Dynamic Range
Better than 100dB
Channel Separation
Better than 98dB (1,000Hz)
System Driver Complement
One 4 inch Woofer/Midrange One 3/4 inch Dome Tweeter
Impedance
8 ohms Nominal
Frequency Response
60Hz - 45kHz
Sensitivity
80dB (2.83V/1m equivalent)
Crossover Frequency
2,000Hz
Power Handling
75 Watts
Finish Enclosure
High Gloss Black
Finish Grille
Black Knit Cloth
Power Requirements
100V ~ 50/60Hz at 3.0 Amps
110V ~ 50/60Hz at 2.5 Amps
120V ~ 50/60Hz at 2.5 Amps
220V ~ 50/60Hz at 1.5 Amps
230V ~ 50/60Hz at 1.3 Amps
240V ~ 50/60Hz at 1.3 Amps
Standby: Less than 0.5 watt
Note: Refer to the rear panel of the MXA60 for the correct voltage.
System Overall Dimensions
Width is 22 inches (55.88cm)
Height is 10-7/8 inches (27.62cm)
Depth is 16 inches (40.64cm) including connectors
Note: When the Disc Player Tray is opened, the panel clearance required
in front of mounting panel is 6-3/4 inches (17.2cm).
System Weight
64 pounds (29.03 Kg) net, 80 pounds (36.28 Kg) in shipping carton
System Shipping Carton Dimensions
Width is 35 inches (88.9cm)
Depth is 20 inches (50.8cm)
Height is 15-1/2 inches (39.4cm)
Amplier Specications
Power Output
75 watts into an 8 ohm load is the minimum sine wave continuous aver-
age power output, both channels operating
Output Load Impedance
8 ohms
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
0.05% maximum harmonic distortion at any power level from 250 mil-
liwatts to rated power, 20Hz to 20,000Hz
Dynamic Headroom
1.6dB
Frequency Response
+0, -0.5dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Main/Sub Output
1.2V for rated input (4V Maximum)
Sensitivity (for rated output)
Input 1: 300mV unbalanced Input 2: 600mV balanced
Signal To Noise Ratio (A-Weighted)
CD, Input1, Input 2: 98dB below rated output
Intermodulation Distortion
0.05% maximum, if the instantaneous peak power output is 150 watts
or less per channel with both channels operating for any combination of
frequencies from 20Hz to 20,000Hz
Wide Band Damping Factor
Greater than 100
Input Impedance
Input 1: 20K ohms unbalanced Input 2: 20K ohms balanced
Maximum Input Signal
Input 1: 4V Input 2: 8V
Main/Sub Output Impedance
500 ohms
Power Guard
Less than 2% THD with up to 12dB overdrive at 1,000Hz
Voltage Gain
Input 1 and 2 to Main Output: 12dB
Power Amplier: 26dB
Tone Controls (Bass and Treble)
Bass ±10dB (in 1dB steps) at 70Hz
Treble ±10dB (in 1dB steps) at 10kHz
Headphone Impedance
20-300 ohms
FM Tuner Specications
Tuning Range
87.5Mhz - 108.0Mhz (Europe)
87.9Mhz - 107.9Mhz (USA)
76Mhz - 90Mhz (Japan)
Antenna Input
75 Ohms, Type “F” Coax connector
Useable Sensitivity
2.2uV (18.1dBf)
50dB Quieting Sensitivity
1.5uV (14.8dBf)
Signal To Noise Ratio
Mono: 70dB Stereo: 68dB
Frequency Response
±1dB 20 to 15,000Hz
Harmonic Distortion
Mono: 0.4% Stereo: 0.8%
Channel Selectivity
60dB Adjacent Channel 66dB Alternate Channel
Stereo Separation
38dB

Related product manuals