Need help?Do you have a question about the Mclane 137-3.5-CA and is the answer not in the manual?
General| Brand | Mclane |
|---|---|
| Model | 137-3.5-CA |
| Category | Lawn and Garden Equipment |
| Language | English |
Be thoroughly familiar with controls and proper use of equipment before operation.
Inspect area, wear protective gear, check fuel, and ensure guards are in place before starting.
Start engine carefully, keep clear of blade, adjust speed, and stop when crossing surfaces.
Check tightness, keep engine clean, and store properly to ensure safe operation.
Connect handle, lower support, and brace using bolts and nuts, ensuring proper alignment.
Fill engine with correct oil and fuel outdoors, handling flammable materials with care.
Familiarize with controls and check engine oil level before starting the unit.
Position the blade horizontally for trimming or vertically for edging using the lever.
Use the lever to engage/disengage the blade and regulate cutting depth or height.
Regulate engine speed using the throttle lever, setting to FAST for operation and SLOW for idle.
Start engine with clutch disengaged, engage drive to cut, and disengage to stop.
Adjust wheel spacer based on cutting position (vertical or angled) before operation.
Handle blade with care, use protective covering, and ensure nuts are tight after changes.
Loosen nut with wrenches, replace blade with correct type, and tighten securely.
Grease cutter head body occasionally with #2 multi-purpose grease.
Check fuel, spark plug, throttle position, carburetor, and gas freshness.
Inspect spark plug wire, carburetor adjustment, and air cleaner condition.
Check for dirt in gas, dirty air cleaner, water in fuel, or plugged vents.
Verify spark plug condition, carburetor adjustment, and air cleaner cleanliness.
Adjust carburetor idle speed, spark plug gap, and idle mixture settings.
Adjust carburetor, clear obstructions, clean fins, and check oil level.
To Next Page