EasyManua.ls Logo

McLED Delta 50 User Manual

Default Icon
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Rozměry pro instalaci (mm)
LED reektory Delta
Delta 50, Delta 100, Delta 150
Delta 200, Delta 300
LED reectors Delta
Delta 50, Delta 100, Delta 150
Delta 200, Delta 300
LED scheinwerfer Delta
Delta 50, Delta 100, Delta 150
Delta 200, Delta 300
Produkt opatrně rozbalte a zkontrolujte
Pokud je nový produkt jakkoliv poškozen, okamžitě ho reklamujte v původním balení
Prosíme, nepokoušejte se používat poškozený výrobek
Svítídlo nepřipojujte k elektrické síti, je-li pod napětím
Než začnete s instalací
Instalační manuál
Poznámky k bezpečnosti:
- v případě, že dojde k rozbití skla, světlo nepoužívejte a zajistěte jeho výměnu
- důležité: Nedotýkat se světla při provozu či krátce po vypnutí - hrozí popálení!
Nechte svítidlo vychladnout! - nezakrývat, umístit mimo dosah hořlavých látek
- varování: vyhněte se styku vnitřních částí svítidla s vodou
- nedívejte se z malé vzdálenosti do svítidla, vystavujete se riziku poškození zraku
- nestmívat! Rozhodně nepoužívat v kombinaci se stmívatelnými okruhy
- nerozebírejte svítidlo - nezasahujte a nepřenastavujte nastavovací prvky
elektronických obvodů svítidla.
- instalaci a servis mohou provádět pouze kvalikované osoby.
Instalace
Zkontrolujte správné zapojení a zapněte napájení.
Svítidlo upevněte pomocí hmoždinek a vrutů, použijte k upevnění oba krajní otvory, dle obr. A.
Připojte modrý vodič na „N“, hnědý vodič na „L“ a žluto-zelený k zemnícímu vodiči.
Nastavte svítidlo do požadovaného úhlu dle obr. B.
McLED® záruka
McLED s. r. o. poskytuje záruku na LED svítidla v délce 3 roky.
V případě reklamace má odběratel právo na náhradu účelně vynaložených nákladů spojených s reklamací pouze v souvislosti
s náklady na dopravu, která je předem odsouhlasena s prodávajícím. Pro posouzení oprávněnosti reklamace musí mít vždy
výrobce možnost posouzení správnosti instalace LED svítidla a to přímo na místě instalace.
Dovozce: McLED s. r. o. , Vídeňská 185, 252 50 Vestec, tel.: +420 220 184 800, fax: +420 244 910 700, e-mail: oce@mcled.cz, www.mcled.cz
Before you start installation
Installation Manual
Safety notes:
McLED® warranty
- In case of glass breaking, do not use the luminaire and ensure its replacement
- Important: Do not touch the luminaire during operation or shortly after turning
o - risk of burning! Let the luminaire cool down! - Do not cover, place away from
ammable substances
- Warning: Prevent contact of the luminaire internal parts with water
- Do not look at the luminaire from a short distance; there is a risk of injury to the eyes
- Do not dim! Under any circumstances, do not use in combination with dimming circuits
- Do not disassemble the luminaire - do not adjust or reset electronic
components of the luminaire circuits.
- Installation and service may only be performed by qualied persons.
Installation dimensions (mm)
Installation
Mount the luminaire with dowels and screws. Use both lateral holes according to Fig. A. Adjust
the luminaire to the desired angle to Fig. B.
Connect the blue wire to "N", brown wire to "L" and yellow-green wire to the
grounding conductor. Check for correct connection and turn power on.
Unpack product and check it carefully
If the product is damaged in any way, submit your claim together with the product in
its original packaging Please, do not use the damaged product
Do not connect the luminaire to the live mains
McLED s.r.o. (Ltd.) provides a three-year warranty on LED luminaires.
In case of a claim, the customer is entitled to compensation for costs associated with claims only in connection with shipping
costs, which shall be approved by the seller in advance. To determine the legitimacy of the claim, the manufacturer must always
have the option of assessing the correctness of the LED luminaire installation on the site where it is installed.
Importer: McLED s. r. o. , Vídeňská 185, 252 50 Vestec, tel.: +420 220 184 800, fax: +420 244 910 700, e-mail: oce@mcled.cz, www.mcled.cz
Vor der Installation
Installationshandbuch
Sicherheitshinweise:
McLED® Garantie
- Beim Glasbruch den Leuchtkörper nicht verwenden und seinen Ersatz veranlassen
- wichtig: Leuchtkörper im Betrieb oder kurz nach dem Abschalten nicht berühren -
Verbrennungsgefahr! Leuchtkörper abkühlen lassen! - nicht verdecken, außerhalb der
Reichweite von brennbaren Stoen anbringen
- Warnung: Kontakt der innenliegenden Teile des Leuchtkörpers mit Wasser vermeiden
- nicht in kleiner Entfernung in den Leuchtkörper blicken, drohende Augenschäden
- nicht dimmen! Nie mit dimmbaren Schaltkreisen verwenden
- Leuchtkörper nicht zerlegen - in die Einstellelemente elektronischer Schaltkreise des
Leuchtkörpers nicht eingreifen und nicht verändern.
- Die Installation und Instandhaltung dürfen nur qualizierte Personen durchführen.
Einbaumaße (mm)
Installation
Den Leuchtkörper mit Dübeln und Schrauben befestigen, zur Befestigung beide Randlöcher
verwenden, siehe Abb. A. Den Leuchtkörper in gewünschten Winkel ausrichten, siehe Abb. B.
Das blaue Kabel an „N“, braune Kabel an „L“ und gelb-grünes Kabel an die Erdungsleitung
anschließen. Auf richtigen Anschluss prüfen und Spannungsversorgung einschalten.
Das Produkt vorsichtig auspacken und überprüfen
Bei jeder festgestellten Produktbeschädigung ist das Produkt sofort in der
Originalverpackung zu reklamieren. Versuchen Sie bitte nicht das beschädigte Produkt zu verwenden
Den Leuchtkörper nicht an das Stromnetz unter Spannung anschließen
McLED s. r. o. gewährt für die LED-Leuchtkörper eine Garantie von 3 Jahren.
Bei einer Beanstandung hat der Abnehmer das Recht auf den Ersatz der zweckmäßig aufgewendeten Kosten im Zusammenhang
mit der Beanstandung betreend lediglich die Transportkosten, die vorab mit dem Verkäufer abzustimmen sind. Zur Beurteilung
der Legitimität der Beanstandung muss dem Hersteller immer die Möglichkeit gegeben werden, die Richtigkeit der Installation der
LED-Leuchtkörper direkt vor Ort zu überprüfen.
Importer: McLED s. r. o. , Vídeňská 185, 252 50 Vestec, tel.: +420 220 184 800, fax: +420 244 910 700, e-mail: oce@mcled.cz, www.mcled.cz
DELTA DELTA DELTA
2,1±0,3 kg 3,4±0,3 kg 4,5±0,3 kg 5,5±0,3 kg 8,3±0,3 kg
300x240x69Size
Weight
Input Voltage 220-240 VAC
Working
Temperature
Storing
Temperature
-30°C +50°C
-40°C +70°C
50W 100W 150W 200W 300W
Product
Specications
335x295x71 375x320x75 400x345x78 464x410x83
2,1±0,3 kg 3,4±0,3 kg 4,5±0,3 kg 5,5±0,3 kg 8,3±0,3 kg
300x240x69Size
Grosse
Eingangs-
spannung
220-240 VAC
Arbeiten
Temperatur
Speicherung
Temperatur
-30°C +50°C
-40°C +70°C
50W 100W 150W 200W 300W
Produkt
Spezikationen
335x295x71 375x320x75 400x345x78 464x410x83
2,1±0,3 kg 3,4±0,3 kg 4,5±0,3 kg 5,5±0,3 kg 8,3±0,3 kg
300x240x69Velikost
Váha
Vstupní napětí 220-240 VAC
Pracovní
teplota
Skladovací
teplota
-30°C +50°C
-40°C +70°C
50W 100W 150W 200W 300W
Technické
údaje
335x295x71 375x320x75 400x345x78 464x410x83
17Nm
M10
2pcs
A
B
17Nm
M10
2pcs
A
B
17Nm
M10
2pcs
A
B
66 66 6666
50.
000
h
50.
000
h
50.
000
h
50.
000
h
50.
000
h
50.
000
h
DELTA
17Nm
M10
2pcs
A
B
17Nm
M10
2pcs
A
B
17Nm
M10
2pcs
A
B
Question and Answer IconNeed help?

Do you have a question about the McLED Delta 50 and is the answer not in the manual?

McLED Delta 50 Specifications

General IconGeneral
BrandMcLED
ModelDelta 50
CategoryLantern
LanguageEnglish

Summary

McLED DELTA IP66 Installation Manual

Before you start installation

Unpack product carefully, check for damage, and do not use if damaged.

Safety notes

Important safety precautions: avoid touching hot surfaces, water contact, and direct eye exposure.

LED reflectors Delta Product Specifications

Details product specifications and dimensions for Delta 50, 100, 150, 200, 300 models.

Installation Guide

Instructions for mounting the luminaire using screws and connecting wires.

McLED Warranty Information

Details the three-year warranty and customer claim procedures for LED luminaires.