MCM HOUSE JOE BED - User Manual

JOE BED
Assembly instructions
- We suggest you spend a short time reading through this leaet and then follow the simple step by step instructions.
- Do not discard any of the packaging until you have checked that you have all the parts and the pack of ttings.
MCM HOUSE
PARTS
1
- Assemble 2 x legs (F) to the under side of Headboard (A).
- Screw 4 x thread (G) into the headboard by hand.
- Tighten until Thread G can be screwed no further.
JOE BED | MCM HOUSE T. 1300 997 975 | MCMHOUSE.COM
PAGE 1 OF 4
2
- Assemble Side plates B and C to headboard, ensuring thread G is visible in the side plate cut out holes.
- Once side plates and headboard are rmly pushed together and components L, N, M and I are in place (refer to drawing) tighten with spanner P.
- Tip - before using Spanner P, screw components L, M, N and I by hand as tight as possible - this will save time. Then tighten down with Spanner P.
A
F
F
A
B
C
L
N
M
I
P
A
Headboard
1x
B
Le side plate
1x
C
1x
Right side plate
D
Footboard
1x
E
Slats
1x
F
4x
G
M8
8x
H
M8x30mm
36x
I
M8
14x
J
8x
K
2x
L
46x
Spring washer
Ø13mm
M
46x
Flat washer
Ø18mm
O
1x
Allen Key
P
1x
Spanner
M8
G
G
N
8x
G
G
G
G
2 people
required for
assembly

Summary

Bed Parts Identification

Assembly Steps

Attach Legs to Headboard

Assemble two legs (F) to the underside of the headboard (A) and screw four threads (G) into the headboard.

Attach Side Plates to Headboard

Connect side plates (B, C) to the headboard, aligning threads (G), and tighten with spanner (P) after hand-tightening components.

Attach Threads to Footboard

Screw the remaining four threads (G) into the footboard (D) until they cannot be screwed further.

Attach Footboard to Side Plates

Connect the footboard (D) to the side plates (B, C), ensuring threads (G) are visible, and tighten with spanner (P).

Attach Corner Brackets

Fasten corner brackets (J) to pre-drilled holes on headboard (A), side plates (B, C), and footboard (D) using components (H, M, N).

Attach Remaining Feet

Attach the last two feet (F) to the bottom bracket (J) at the foot of the bed and tighten with spanner (P).

Attach Legs to Slat

Attach two legs (K) to the underside of the slat (E) using hardware (O, H, M, N, I, P) and tighten securely.

Fit Bed Cover and Mattress

Unfold and slip the cover over the bed, adjusting for a neat fit, then place the mattress on the slats.

Assembly Safety Warnings

MCM HOUSE JOE BED Specifications

General

Brand	MCM HOUSE
Model	JOE BED
Category	Indoor Furnishing
Language	English